MS35644G
Inches |
mm |
Inches |
mm |
Inches |
mm |
Inches |
mm |
.030 |
0.76 |
. 188 |
4.78 |
.984 |
24.99 |
5.560 |
141.22 |
.050 |
1.27 |
. 375 |
9.53 |
1.310 |
33.27 |
5.625 |
142.88 |
.060 |
1.52 |
.469 |
11.91 |
1.969 |
50.01 |
8.660 |
219.96 |
.065 |
1.65 |
.563 |
14.30 |
2.375 |
60.33 |
10.625 |
269.88 |
.125 |
3.18 |
.625 |
15.88 |
3.563 |
90.50 |
35.500 |
901.70 |
.156 |
3.96 |
.875 |
22.23 |
4.310 |
109.47 |
NOTES:
1. Dimensions are in inches. Tolerances are ± .010 on decimals, ± 1° on angles.
2. Metric equivalents are given for information only.
3. For design feature purposes, this standard takes precedence over acquisition documents referenced herein.
4. In the event of a conflict between the text of this standard and the references cited herein, the text of this standard shall take precedence.
5. This document is not intended to limit construction to features other than as shown herein by dimensions, notations or referenced documents.
FIGURE 1. Filler neck - Continued.
Requirements:
Filler tube MS90908-1 is included as a part of filler neck assembly MS35644-1, -5 and -9.
This neck shall mate with MS35645 cap, fuel tank: tactical vehicle, fording. Specified Test depicted in procurement specification referenced therein shall apply. This neck shall also mate with caps MS51300 and MS53075.
Material: Steel sheet, low-carbon 0.15% maximum, grade 1008 to 1012 HR or CR with temper 4 or temper 5 in accordance with QQ-S-698.
Optional material: ASTM-A1011/A1011M, Grade CS, Type B, ASTM-A1008/A1008M, Grade CS, Type B, or tubing in accordance with ASTM-A513 Grades 1008 or 1010.
Steel sheet or strip hot rolled pickled and oiled or cold rolled oiled, drawing quality ASTM-A507; steel sheet
Carbon cold rolled drawing quality ASTM-A619/A619M; steel carbon cold rolled strip temper 4 or 5
ASTM-A109/A109M.
Joint at filler neck and upper ring shall be air and water tight.
Welding rod shall be type I in accordance with SAE-AMS6457. Resistance spot welding shall be in accordance with AWS-D8.7M and AWS-D8.9M. Arc welding shall be type I in accordance with AWS-D1.1/D1.1M.
Solder shall be composition 40 or 50 in accordance with J-STD-004, J-STD-005, and J-STD-006 or composition
40 or 50 in accordance with ASTM-B32.
Parts shall be free from burrs and sharp edges.
Protective coating prior to installation of strainer: Assembly shall be protected with zinc coating in accordance with
ASTM-A153/A153M or zinc coating (electrodeposited) in accordance with ASTM-B633, Fe/Zn 5, type VI.
Guide shall properly position and support filler tube MS90908-1 without binding.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business