MIL-DTL-45300C
2.2 Other publications. The following document forms a part of this specification to the extent specified herein.
Unless otherwise specified, the issues of the documents which are DOD adopted shall be those listed in the issue of
the DODISS specified in the solicitation. Unless otherwise specified, the issues of documents not listed in the
DODISS shall be the issue of the nongovernment documents which is current on the date of the solicitation.
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION (ISO)
ISO 17025
-
General requirements for the competence of testing and calibration laboratories
(Copies of these documents are available online at https://www.iso.ch or from the International Organization for
Standardization American National Standards Institute, 11 West 42nd Street, 13th Floor, New York, NY 10036.)
NCSL INTERNATIONAL
NCSL Z540.3
-
Laboratories, Calibration, and Measuring and Test Equipment
(Copies of these documents are available online at https://www.ncsli.org or from NCSL International 2995
Wilderness Place, Suite 107 Boulder, Colorado 80301-5404)
2.3 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection in accordance with
4.4.
3.2 Materials (all types). Materials shall be as specified herein and in referenced specifications, standards and
drawings. Materials shall be free of defects which adversely affect performance or serviceability of the finished
product (see 4.6.1).
3.2.1 Recycled, virgin and reclaimed materials. There are no requirements for the exclusive use of virgin
materials. The use of recycled or reclaimed (recovered) materials is acceptable provided all other requirements of
this specification are met (see 6.3.1).
3.3 Construction (all types) (see 4.6.1 and 4.6.2).
3.3.1 Type I. Type I caps shall conform to MS51300.
3.3.2 Type II. Type II caps shall conform to MS35645.
3.3.3 Type III. Type III caps shall conform to MS53075.
3.4 Performance.
3.4.1 Torque.
3.4.1.1 Caps (all types). When connecting the cap to a filler neck conforming to MS35644 at temperatures of plus
125 to minus 65 degrees Fahrenheit (°F), the torque shall be no greater than 70 inch-pounds attained before the cap
hits the stop limit. The torque required to disconnect the cap from the filler neck at temperatures of plus 125 to minus
65°F shall be not greater than 70 nor less than 25 inch-pounds. There shall be no visible evidence of binding (see
4.6.3.1).
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business