INCH-POUND
MIL-DTL-62011E
27 July 2009
SUPERSEDING
MIL-DTL-62011D
7 September 1999
DETAIL SPECIFICATION
PUMP, FUEL, ELECTRICALLY-OPERATED:
24-VOLT DC, IN-TANK TYPE, GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers electrically-operated 24-volt (V), direct current (dc), in-tank fuel
pumps capable of delivering 200 gallons per hour (gph) with outlet pressure at 4 pounds per square inch
gauge (psig) (see 6.1).
1.2 Part or Identifying Number (PIN). The PIN consists of the letters M, the basic specification
number, specification sheet number, a dash, and the connector type.
M
60211
/1
-
000
- H
Finish
Cable length (inches)
Specification sheet number
Specification number
M prefix
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3, 4, or 5 of this
specification. This section does not include documents cited in other sections of this specification or
recommended for additional information or as examples. While every effort had been made to ensure the
completeness of the list, document users are cautioned that they must meet all specified requirements
documents cited in sections 3, 4, or 5 of this specification, whether or not the are listed.
Comments, suggestions, or questions on this document should be addressed to: Defense Supply
Center, Columbus, Attn: DSCC-VAI, P.O. Box 3990, Columbus OH 43218-3990, or emailed to
FluidFlow@dla.mil. Since contact information can change, you may want to verify the currency of this
address information using the ASSIST Online database at https://assist.daps.dla.mil.
ASMC N/A
FSC 2910
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business