MIL-DTL-62011E
SOCIETY OF AUTOMOTIVE ENGINEERS, INC. (SAE)
SAE-AMS 2417
-
Plating, Zinc-Nickel Alloy
SAE-AMS-QQ-N-290
-
Nickel Plating (Electrodeposited)
SAE-AMS-QQ-P-416
-
Cadmium Plating (Electrodeposited)
SAE-AMS-STD-753
-
Corrosion-Resistant Steel Parts: Sampling, Inspection and
Testing for Surface Passivation
(Copies of these documents are available online at https://www.sae.org or from the SAE World
Headquarters, 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. Unless otherwise noted here in or in the contract, in the event of a conflict
between the text of this document and the references cited herein (except for related specification
sheets), the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in
accordance with the applicable specification sheet. In the event of any conflict between requirements of
this specification and the specification sheets, the latter shall govern.
3.2 First article. When specified (see 6.2), a sample shall be subjected to first article inspection in
accordance with 4.4.
3.3 Materials.
3.3.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life-cycle cost.
3.3.2. Pump motor housing. The pump motor housing shall be made of CRES.
3.3.3 Pump body, mounting bracket and hardware plating. The pump body, mounting bracket and
3.3.4 Cadmium plating. All steel alloys other than CRES.
3.3.4.1 Electrical cable connectors. Electronic cable connector's shall be cadmium plating in
accordance with SAE-AMS-QQ-P-416, type 1, class 1.
3.3.4.2 Screws, nuts, and bolts. Screws, nuts, and bolts shall be cadmium plated in accordance with
SAE-AMS-QQ-P-416, type II, class 3.
3.3.4.3 Cushion retainer, pump cover, and discharge tube fitting. Cushion retainer, pump cover, and
discharge tube fitting shall be cadmium plated in accordance with SAE-AMS-QQ-P-416, type I, class 2.
3.3.4.4 Cadmium is not recommended. Carbon steel material with cadmium plating shall only be
used when other materials and finishes specified in this document cannot meet performance
requirements (see 6.5).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business